Energy Implications of In-Line Filtration in California Homes

Date Published
12/2012
Publication Type
Journal Article
Authors
LBL Report Number
LBNL-6379E
Abstract

Furnace energy use and filter pressure drop was measured for forced-air heating/cooling systems in ten California homes. Each home was monitored for at least one year. Measurements were made of the blower energy, filter pressure drop, supply and return plenum pressures, and temperatures, as well as the indoor temperature. At least two filter types were installed, including a MERV 16 filter, in most houses. As the filter became dirty, in some homes the blower energy use increased, and in others the blower energy use decreased. Increasing blower energy use was associated with BPM blower motors, and decreasing blower energy was associated with PSC blower motors. There was a large pressure drop across the MERV 16 filter as compared to the lower-MERV filters. Many homeowners complained of noise because of the large pressure drop and air bypassing the filter.

In addition to field measurements, simulations were made for a typical new home in six California climate zones, with combinations of PSC and BPM blowers, and low and high duct leakage. The results indicate that for MERV 10–13 filters, as compared to a baseline of MERV 5, the effects on blower energy use are moderate (<5%) over a wide range of performance conditions and climates. Using MERV 16 filters leads to problems in terms of noise, usability, and potential for significantly increased blower energy use (about 20%). In systems that are already close to blower performance limits with low-MERV filters, the addition of a MERV 16 filter pushed the blowers to their performance limits. The effect of filter loading on total HVAC system energy performance was small (<1%) for most homes. However, with high filter loading rates for MERV 16 filters, the performance deteriorated significantly (up to 20% increases in energy use for a system with a leaky duct and a BPM blower) indicating that a filter loading indicator should be required for MERV 16 filters.

Journal
ASHRAE Transactions
Volume
19
Year of Publication
2012
Issue
2
Pagination
99-417
Organizations
Research Areas
Download citation